Abrasive & Blast Inspection
Blasting parameters: A number of important parameters need to be monitored during the blasting or water jetting process, these include: air pressure (at the nozzle), nozzle diameter, blast media contamination & pH values in order to avoid recontamination of the substrate during blasting.
- Coatings Inspection Division
- Abrasive & Blast Inspection
- Surface Roughness
- Climate, Dewpoint & Relative Humidity
- Moisture Measurement
- Oven Temperature Profile
- Wet Film & Powder Thickness
- Dry Film Thickness
- Material Thickness
- Adhesion Testers
- Dry Film Thickness
- ElcoMaster® Software
- Surface Condition
- Surface Profile
- Surface Cleanliness
- Pinhole & Porosity
- Inspection Kits
-
product
pH Tester
148
The Elcometer 148 sensor has automatic temperature compensation, ensuring like-for-like measurements can be taken for meaningful comparison of the results.Simultaneously displays pH and temperatureMeasurement hold / freeze functionRecord maximum and minimum readings over a series of tests°C / °F user switchableWaterproof to IP57 and floats on waterAuto power off
-
product
Chloride Ion Test Kit for Water
134W
The Elcometer 134W is used to monitor recycled water (after it has been applied) to establish effectiveness of salt removal, this test is ideal for testing the salt contamination in wash water and blast water.
-
product
Chloride Ion Test Kit for Abrasives
134A
Contamination can build up, particularly if the blast media is recycled several times. Using the Elcometer 134A Chloride Ion Test in the field will accurately identify contamination and prevent costly surface-related failures.
