Filter Results By:
Products
Applications
Manufacturers
-
product
SSD
CFAST-B-XXG-SI
The CFAST-B-XXG-SI is a USA-made product line of Industrial SLC-based CFast memory cards. These small form factor CFast cards provide SATA level performance while featuring robust features needed for industrial applications. These cards contain a locked-down Bill of Materials to ensure consistent product performance and future compatibility.
-
product
SSD
M.2 SSD (MLC)
Innodisk M.2 (S42) 3ME4 is characterized by L3 architecture with the latest SATA III (6.0GHz) Marvell NAND controller. Innodisk’s exclusive L3 architecture is L2 architecture multiplied LDPC (Low-Density Parity Check). L2 (Long Life) architecture is a 4K mapping algorithm that reduces WAF and features a real-time wear-leveling algorithm to provide high performance and prolong lifespan with exceptional reliability.
-
-
product
SSD
MSATA SSD (iSLC) 3IE4 Series
Innodisk mSATA 3IE4 is SATA III 6.0 Gb/s flash-based disk, which adopts the latest Marvell NAND controller with Innodisk’s exclusive L³ FW architecture. The upgraded L³ FW architecture, combining Innodik signature 4K mapping algorithm L² FW architecture with powerful LDPC technology, makes 3IE4 series have outstanding high IOPS, better data integrity, and extended lifespan by reducing the occurrence of bad block numbers. Built-in thermal sensor and iData Guard ensure data integrity and reliability of mSATA 3IE4 for industrial applications.
-
-
product
SSD
M.2 SSD (iSLC)
Innodisk M.2 (S42) 3IE4 is characterized by L3 architecture with the latest SATA III (6.0GHz) Marvell NAND controller. Innodisk’s exclusive L3 architecture is L2 architecture multiplied LDPC (Low-Density Parity Check). L2 (Long Life) architecture is a 4K mapping algorithm that reduces WAF and features a real-time wear-leveling algorithm to provide high performance and prolong lifespan with exceptional reliability.
-
product
SSD
MSATA SSD (MLC) 3ME4 Series
Innodisk mSATA 3ME4 is SATA III 6.0 Gb/s flash based disk, which adopts latest Marvell NAND controller with Innodisk’s exclusive L³ FW architecture. The upgraded L³ FW architecture, combining Innodisk signature 4K mapping algorithm L² FW architecture with powerful LDPC technology, makes 3ME4 series have outstanding high IOPS, better data integrity and extended lifespan through reducing the bad block number happening. Built-in thermal sensor, and iData Guard ensure data integrity and reliability of mSATA 3ME4 for industrial applications.
-
product
SSD Life
SSD Life analyzes how actively you use your solid-state drive and uses a special algorithm to calculate its estimated lifetime. Of course, the date of the lifetime expiration is corrected depending on how intensively you keep using your drive.
-
product
mSATA SSD Carrier
SD3-GLISS
SD3-GLISS fits into any CompactPCI® Serial peripheral slot that is PCIe enabled. Hardware RAID operation is supported, running with an enhanced ARM-based processor to offload the host CPU.
-
product
SSD Test Dystems
MPT3000HES / MPT3000HES2
Compact, highly efficient SSD test solution allows customers to accelerate time to qualification for their new designs and time to market for their latest storage products.
-
product
SSD Test System
The Neosem’s SSD test system combines advanced SSDtest hardware, software and environmental chamber into a single platform and supports all popular storage interfaces including PCIe, SAS & SATA and fast emerging protocols such as NVMe and AHCI.
-
product
SSD Test Systems
MPT3000HVM / MPT3000HVM2
As the SSD market continues to grow, device manufacturers need a low-cost way to test their expanding product portfolios. The MPT3000HVM and MPT3000HVM2 testers provide broad capabilities to handle virtually any SSD, from the highest performing enterprise drives to the most cost-effective client devices. This unmatched functionality presents a major advantage in the rapidly changing SSD market.
-
product
SSD Test Systems
Enables Rapid SSD Development and Production Ramp with Flexible Test Solution In the high-growth and highly competitive SSD market, a test system that supports multiple protocols can eliminate the need for retooling and achieve faster transitions from one product version — or one product generation — to the next. Advantest SSD Test System allows manufacturers to rapidly grow their product portfolios while remaining adaptable to the many changing needs of the evolving SSD market. This tester improves users’ engineering efficiency with powerful, easy-to-use software tools and a revolutionary multi-protocol hardware architecture, enabling accelerated SSD product development and a faster time-to-manufacturing ramp.
-
product
SSD Test Systems
MPT3000ES / MPT3000ES2
Using the same high-performance electronics and powerful software as all products in the MPT3000 family, the MPT3000ES and MPT3000ES2 engineering stations feature a small footprint configured to test up to eight SSDs in parallel. The system's small size and ability to plug into a standard AC outlet enable users to conduct program development and interactive device debugging in either office or lab settings.
-
product
Storage SSD Adapter Card
Shenzhen Sintech Electronic, Inc.
You can find from here all kinds of HDD/SSD adapter card and DIY upgrade Card for computer: SATA 22PIN,Micro SATA 16pin,SATA LIF,mini SATA mSATA,Macbook Air/PRO/IMAC/ASUS Ultrabook UX21.UX31/Lenovo X1 mini SATA SSD,NGFF M.2 SSD.
-
product
PXIe SSD Storage Unit
DM-4M.2-3U
The Big River™ DM-4M.2-3U PXI Express storage unit provides up to 3.8TB* of M.2 SSD storage capacity. With a PCIe x8 Gen3 host interface, the DM-4M.2 delivers high-speed data rates for sequential writes of 3.25GB/s** and sequential reads of 3.41GB/s** to PXI Express based systems. The single slot design of the DM-4M.2 increases the availability of valuable chassis space, allows for maximum storage flexibility. The DM-4M.2 complies with PCIe Gen3 protocol standards. The product is commonly used in the industrial control, test and measurement fields. The DM-4M.2 operates under Windows, Linux, Unix, Solaris and VxWorks.
-
product
mSAT SSD for Industrial Embedded Applications
mSATA SSD Series
ADLINK’s mSATA SSD Series with the SATA 6Gb/s interface is fully compliant with the standard mSATA form factor, also known as JEDEC MO300. Utilizing Toggle 2.0 MLC flash technology, capacities of up to 1TB are available with support for read/write speeds of up to 550MB/sec and 500MB/sec respectively . Additionally, the power consumption of the ADLINK’s mSATA modules is much lower than that of traditional hard drives.
-
product
SSD - Solid State Storage Devices
LinkedHope Intelligent Technologies Co.,Ltd.
LinkedHope Intelligent Technologies SSD Products
-
product
M.2 SATA SSD Carrier
SD4-SWEEP
SD4-SWEEP fits into any CompactPCI® Serial peripheral slot that is PCIe enabled. Hardware RAID operation is supported, running with an enhanced ARM-based processor to offload the host CPU.
-
product
Arowana PCI Express SSD Board Family x1 PCI Express Gen 3 SSD Board
SKU-090-31-x1
The Arowana PCI Express SSD board is the smallest carrier board on the market. This PCI Express Carrier board was designed to expand modern motherboards or embedded systems that have a PCI Express interface. It can also be vertically installed in any 1U servers or appliances.
-
product
RunCore Embedded PATA “Elite Series” SSD
2.5"PATA/IDE SSD
RunCore Innovation Technology Co. Ltd.
2.5” PATA SSD incorporates advanced flash controller and NAND flash memory technology to deliver a state-of-the-art, non-volatile mass storage device. It supports capacity from 32GB to 128GB. 2.5” PATA Plus SSD contains the cache size of up to 64MB with maximum transfer rate as high as 95MB/s. Furthermore, its characteristics of low power consumption and anti-vibration are obvious.
-
product
Arowana PCI Express SSD Board™ Family x4 PCI Express Gen 3 SSD board
SKU-090-31-x4
The Arowana PCI Express SSD board is the smallest carrier board on the market. This PCI Express Carrier board was designed to expand modern motherboards or embedded systems that have a PCI Express interface. It can also be vertically installed in any 1U servers or appliances.
-
product
MO300 MSATA3 RunCore Consumer SSD “Sprinter Series”
RunCore Innovation Technology Co. Ltd.
mSATA3 (6Gbps) Solid State Drive (SSD) is a high capacity solid-state flash memory product that complies with the SATA 6Gbps standard and is functionally compatible with a SATA hard disk drive.
-
product
Dual M.2 Card SSD Mezzanine Module
C48-1-M2
C48-M2 connects to the mezzanine expansion connector HSE of the CompactPCI® CPU carrier. 4HP envelope of the CPU carrier board, but can also be used on some mezzanine side cards, for an 8HP or 12HP total front panel width assembly.
-
product
XMC-PCIeStor, High Speed PCIe Single SSD Adapter
9301
The 9301 is a VITA 42.3 XMC adapter card / mezzanine storage module with a single M.2 SSD site. The M.2 site supports up to 4 lanes of PCIe Gen 2 connectivity at 5 Gb/s per lane when a Gen 2 or 3 capable M.2 PCIe card is used.
-
product
2.5 inch SATA SSD for Industrial Embedded Applications
2.5 inch SATA SSD Series
ADLINK’s industrial 2.5 inch SATA SSD Series delivers all the advantages of today’s flash disk technologies with SATA 6Gb/s interface, and is fully compliant with the standard 2.5" form factor, providing low power consumption and hot-swap capability. Capacities of up to 2TB are available and read/write speeds of up to 560MB/s and 500MB/s respectively are supported.
-
product
2.5” SATA3 – RunCore Consumer SSD "Sprinter Series"
RunCore Innovation Technology Co. Ltd.
Standard 2.5” SATA3 (6Gbps) Solid State Drive (SSD) is a high capacity solid-state flash memory product that complies with the SATA 6Gbps standard and is functionally compatible with a SATA hard disk drive. It is a standard SATA product that supports both 7mm and 9mm thickness.
-
product
Arowana PCI Express SSD Board™ Family 2U x16 (x8) PCI Express Gen 3 SSD board
The Arowana PCI Express SSD board incorporate up to eight independent x4 PCI express Gen 3 SSDs. The operating system recognizes each SSD as an individual hard disk and can combine them in RAID0 to gain maximum performance.
-
product
Half Slim SATA3 RunCore Consumer SSD “Sprinter Series”
RunCore Innovation Technology Co. Ltd.
Half-Slim SATA3 (6Gbps) Solid State Drive (SSD) is a high capacity solid-state flash memory product that complies with the SATA 6Gbps standard and is functionally compatible with a SATA hard disk drive.
-
product
MO300 MSATA3 RunCore Embedded SATA3 “Elite Series” SSD
RunCore Innovation Technology Co. Ltd.
MO300 mSATA3 utilizes high-performance SATAIII SSD controller and NAND flash, with or with no DRAM buffer to support power failure mechanism. This series SSD compliant with Serial ATA Revision 2.6/3.1 specification, compatible with 6.0Gbps, 3.0Gbps and 1.5Gbps interface rate and support Native Command Queuing (NCQ) up to 32 commands. As a standard SATA drive, it can support mainstream OS, such as Windows/Linux/Unix/Solaris/ Mac OS and so on.
